What are the steps to use the labeling machine?

The main working mechanism of the labeling machine is composed of a label feeding device, a label receiving device, a printing device, an adhesive device and a locking device.

• What role does PLC control play in the labeling machine?

• How to adjust the station label of the labeling machine?

• How do I set the label box of the labeling machine?

What role does PLC control play in the labeling machine?

The PLC control in the labeling machine is used to control the work of each electrical device in the entire labeling machine. Its working principle: the external signal (usually the object signal or foot signal) is entered into the control center (usually PLC), the control center sends out a control signal after analysis and processing, and controls the rotation of the motor to rotate the tensile mechanism to realize the labeling of the label. When removing the backing paper, the label is removed and glued to the surface to be applied.

How to adjust the station label of the labeling machine?

Adjustment of the squeegee and the rubber roller of the labeling machine: There must be no gap between the squeegee and the rubber roller along the entire length. If there is a gap, the suction foot can be adjusted by adjusting the eccentric bolts.

Adjustment of the rubber roller and the target plate: The target plate and the rubber roller are only pressed against each other without pressure. If the gap is too large, there will be too much glue on the target panel, which will eject glue. If the gap is too small and the contact too tight, the glue is pushed away and there is no glue left on half of the target panel. Practice has shown that the best distance between the target plate and the rubber roller is between 0.1mm and 0.2mm, which can be achieved by adjusting the bearing seat on the lower part of the rubber roller and optionally by adjusting the bearing on the upper part of the rubber roller.

How do I set the label box of the labeling machine?

The center line of the label box and the center axis of the label station of the labeling machine are tangential to the label paper and form a line with the three points of the middle axis of the label plate. Adjust the tangent (contact) between the target plate and the label paper, then move the standard box closer to 1mm to 2mm. The distance between the standard paper in the standard box and the pressure strips on both sides is between 0.8mm and 1mm. that the standard paper moves in the standard box and the phenomenon of oblique marking occurs; The phenomenon. Adjustment of the label feed roller: If the label is missing, the label printing plate can be pressed to the front end of the label box, and if the label is inserted, the label hook (relative to the nearby label) cannot be squeezed. Adjusting the position of the standard box grab hooks: The upper, lower, left and right grab hooks can easily grab the mark if they are on the same vertical plane and are evenly loaded on the standard paper.

Shanghai Paixie Packaging Machinery Co., Ltd. is committed to providing its customers with reliable labeling machines and perfect after-sales service so that customers can easily invest, use them confidently and not worry.